When welding work on the machine, the following provisions shall operate, in order to avoid damage to the machine, or the occurrence of accidents.

1) Before welding, you must read and understand the relevant safety requirements for welding in this machine.

2) Before welding, turn off the engine start switch, disconnect the negative power switch.

3) Before welding, you must remove the instrument panel connector, to avoid damage to the dashboard, you can also harness the cab (in the lower right of the frame is hinged near the cab) and vehicle harness disconnected.

4) continue to use unsustainable over 220V voltage.

5) the welding area and ground cables within a distance of 1 meter.

6) between the weld area and avoid grounding cable seals and bearings.

7) Do not weld or cut have fuel, oil and hydraulic oil pipes and containers.

8) Do not weld or cut a sealed container or poor ventilation.